Surfboards

The Throwback Model is our modern interpretation of the classic Retro Twin Fin Fish developed in the 70’s. We’ve been refining this model for over 15 years and it is designed to cater to a wide variety of surfers and conditions. It works really well in smaller surf due to the wider outline, wider tail and generally low and gradual rocker to help it plane, generate speed and project through flat sections. It also holds a line really well in steeper surf due to the straighter outline thru the back half of the board and thinned out refined retro swallow tail allowing it to easily engage and hold into faster waves. It’s a great board for anyone stepping down from a bigger board as the general width of the outline and tail offer plenty of stability in any type of surf and if you’re looking for a bit of change from your performance shortboard or lower volume groveler – this a great alternative to a longboard or mid length to catch a ton of waves and surf smaller, lower quality waves with a lot more response. Learn More

The Throwback Model is our modern interpretation of the classic Retro Twin Fin Fish developed in the 70’s. We’ve been refining this model for over 15 years and it is designed to cater to a wide variety of surfers and conditions. It works really well in smaller surf due to the wider outline, wider tail and generally low and gradual rocker to help it plane, generate speed and project through flat sections. It also holds a line really well in steeper surf due to the straighter outline thru the back half of the board and thinned out refined retro swallow tail allowing it to easily engage and hold into faster waves. It’s a great board for anyone stepping down from a bigger board as the general width of the outline and tail offer plenty of stability in any type of surf and if you’re looking for a bit of change from your performance shortboard or lower volume groveler – this a great alternative to a longboard or mid length to catch a ton of waves and surf smaller, lower quality waves with a lot more response. Learn More

The Throwback Model is our modern interpretation of the classic Retro Twin Fin Fish developed in the 70’s. We’ve been refining this model for over 15 years and it is designed to cater to a wide variety of surfers and conditions. It works really well in smaller surf due to the wider outline, wider tail and generally low and gradual rocker to help it plane, generate speed and project through flat sections. It also holds a line really well in steeper surf due to the straighter outline thru the back half of the board and thinned out refined retro swallow tail allowing it to easily engage and hold into faster waves. It’s a great board for anyone stepping down from a bigger board as the general width of the outline and tail offer plenty of stability in any type of surf and if you’re looking for a bit of change from your performance shortboard or lower volume groveler – this a great alternative to a longboard or mid length to catch a ton of waves and surf smaller, lower quality waves with a lot more response. Learn More

A close derivative of our best selling mid-length the Diamong Jig – taken to the fish level. We kept the same great elements of gradual smooth rocker, slight vee out the tail (added a touch of a spine through the fin section of this board) and the classic retro swallow tail offers new pivot points as compared to the Diamond Jig feel. Slightly wider tail also offers a straighter rail line and more surface area for increased down the line speed on a little more lack luster waves. Thinner and low 50/50 rails engage easily with the face offering a nice crisp hold when you want it and a bit of belly through the middle offer ease of transitions through the midsection of this board offering a diverse ride & feel in a unique and sexy shape. Think Throwback Retro Fish meets Midlength. Learn More

A close derivative of our best selling mid-length the Diamong Jig – taken to the fish level. We kept the same great elements of gradual smooth rocker, slight vee out the tail (added a touch of a spine through the fin section of this board) and the classic retro swallow tail offers new pivot points as compared to the Diamond Jig feel. Slightly wider tail also offers a straighter rail line and more surface area for increased down the line speed on a little more lack luster waves. Thinner and low 50/50 rails engage easily with the face offering a nice crisp hold when you want it and a bit of belly through the middle offer ease of transitions through the midsection of this board offering a diverse ride & feel in a unique and sexy shape. Think Throwback Retro Fish meets Midlength. Learn More

Who - Launched in 2018, The RNF_RETRO was Lost Surfboards spin towards a more classic, almost 1970’s inspired, fish. Generous dims, low rocker, flat deck, steep rails and wide tail, made catching waves and speeding along, easier than any fish they ever designed. What set the RNF_RETRO apart from the endless schools of fish, was the use of a snowboard inspired design element, reverse radius side-cut, in the outline. When - The RNF Retro can be ridden in just about anything. But this model really favors clean, slopey surf (ranging from knee high to overhead). That is where the characteristics of this board really shine. The right surfer can also take this board in steep surf and reap the benefits of the Retros sheer speed. What - Lost first used side-cut, in our “Pelagic” model, a decade or so earlier. Side-cut outlines are nothing new in surfboards, San Diego pioneers like Mirandon and Caster had used them for ages. We feel the sidecut enables a flat rockered and generally parallel outlined board, to turn sharper and retain speed in tight radius turns. They “lock in” to the wave face and carve, off the rail, without sliding out or digging. The RNF_RETRO uses not one, but two side cut radiuses: one between the feet, starting just behind the wide point and another, shorter/tighter one, right under the rear foot, in place of a hip, or wing. Lost believes this outline lends the RNF_RETRO a truly unique ride in a sea of relentlessly similar “fish”. Here is what …Lost did for the RNF Retro Revamp ’23: • Moved the wide point slightly forward, but gently narrowed/pulled in, the forward 12” of the nose, to get it outta the way, in tighter turning situations. • Deepened the rear side cut, for bite and control, right under the back foot and also added a hint of width to the tail block, for horizontal trim. • Without changing the tip or tail, we adjusted the rocker curves, both fore and aft. The tail rocker hangs lower in the rear third of the board, but then swoops up quickly, though the fins, creating more curve under the rear foot without actually adding rocker. Up front we took a more direct route to the nose, cutting out some of the curve in the forward 1/3rd of the board. At the same time, we eliminated the slight forward vee. • We carried the thickness foil further forward, adding paddle power, ease of entry into waves and front foot drive, to balance the now more curvaceous tail rocker. Learn More

Who - Launched in 2018, The RNF_RETRO was Lost Surfboards spin towards a more classic, almost 1970’s inspired, fish. Generous dims, low rocker, flat deck, steep rails and wide tail, made catching waves and speeding along, easier than any fish they ever designed. What set the RNF_RETRO apart from the endless schools of fish, was the use of a snowboard inspired design element, reverse radius side-cut, in the outline. When - The RNF Retro can be ridden in just about anything. But this model really favors clean, slopey surf (ranging from knee high to overhead). That is where the characteristics of this board really shine. The right surfer can also take this board in steep surf and reap the benefits of the Retros sheer speed. What - Lost first used side-cut, in our “Pelagic” model, a decade or so earlier. Side-cut outlines are nothing new in surfboards, San Diego pioneers like Mirandon and Caster had used them for ages. We feel the sidecut enables a flat rockered and generally parallel outlined board, to turn sharper and retain speed in tight radius turns. They “lock in” to the wave face and carve, off the rail, without sliding out or digging. The RNF_RETRO uses not one, but two side cut radiuses: one between the feet, starting just behind the wide point and another, shorter/tighter one, right under the rear foot, in place of a hip, or wing. Lost believes this outline lends the RNF_RETRO a truly unique ride in a sea of relentlessly similar “fish”. Here is what …Lost did for the RNF Retro Revamp ’23: • Moved the wide point slightly forward, but gently narrowed/pulled in, the forward 12” of the nose, to get it outta the way, in tighter turning situations. • Deepened the rear side cut, for bite and control, right under the back foot and also added a hint of width to the tail block, for horizontal trim. • Without changing the tip or tail, we adjusted the rocker curves, both fore and aft. The tail rocker hangs lower in the rear third of the board, but then swoops up quickly, though the fins, creating more curve under the rear foot without actually adding rocker. Up front we took a more direct route to the nose, cutting out some of the curve in the forward 1/3rd of the board. At the same time, we eliminated the slight forward vee. • We carried the thickness foil further forward, adding paddle power, ease of entry into waves and front foot drive, to balance the now more curvaceous tail rocker. Learn More

Lib Tech designed the Crak’n with one goal; to mimic the feeling of surfing open ocean waves. To achieve this we needed to expand the usable face of the wake so we gave the Crak’n narrow dimensions, a straight rail line, with a fuller nose and overall increased speed efficiency so it can be ridden in smaller lengths. We added slightly higher nose and tail rocker for slashability... wait, we had two goals... we also wanted to blast big airs so we designed a wide scalloped tail and sharpened the edges like a skimboard for throttle and spin control. To top all this off, we unleashed the Particle Accelerator Dish concave in the fin zone for even more speed and boost! Learn More

Aaron WItherell's speedy, poppy pro wake surf shape. The Air’N pro model is Aaron’s dream wake surf design, refined and tuned to perfection. A wide poppy tail block, speedy flat rocker and mellow concave combined with dynamic “up rail” entry to hard edge exit rail design make the Air’N catch-free, precise and perfect for progression. “This boards is unbelievable. I never lack speed or pop and I don’t bury the nose. The durability of the ECO IMPACTO construction is better than I have ever seen. Heel dings and having to worry about dinging your board on the boat are a thing of the past.” - Aaron Witherell Learn More